Rolls-Royce Clyde

The Rolls-Royce RB.39 Clyde was Rolls-Royce's first purpose-designed turboprop engine and the first turboprop engine to pass its civil and military type-tests.

As with subsequent Rolls-Royce gas turbines, it was named after a river, the River Clyde.

Design and development

The Clyde used a two-shaft design, with an axial compressor based on that of the Metrovick F.2 for the low-pressure section, and a single-sided centrifugal compressor scaled up from the Merlin 46 supercharger

as the high-pressure stage, both mounted on the HP shaft and driven by a single stage HP turbine. A single stage power turbine drove the front mounted propeller reduction gearbox via the concentric LP shaft. A fairly novel feature of this compact gearbox was the power output to contra-rotating propellers.

The Clyde was a long engine with the axial LP compressor in front of what was, in effect, a scaled-down Derwent engine. Accessories were grouped around the axial compressor which conveniently narrowed towards the rear. Cooling for turbines and turbine bearings came from a small impeller on the main shaft as well as air taken from the axial and centrifugal compressors. Testing of the development engines exceeded expectations with the engine soon being rated at 4,030 eshp.