thumb|Russian 122 mm shrapnel shell, which has been fired, showing rifling marks on the copper driving band around its base and the steel [[bourrelet nearer the front]]

A driving band or rotating band is a band of soft metal near the base of an artillery shell, often made of gilding metal, copper, or lead. When the shell is fired, the pressure of the propellant swages the metal into the rifling of the barrel and forms a gas seal; this seal prevents the gases from blowing past the shell and engages the barrel's rifling to spin-stabilize the shell.

Purpose

The rotating band has three essential functions:

  • Center the rear end of the projectile in the gun barrel.
  • Seal the bore to prevent burning powder gas from moving through the rifling grooves past the projectile.
  • Engage with the rifling of the barrel to spin the projectile and stabilize its flight.

Characteristics

The shell is stabilized for yaw in the barrel by a smaller bourrelet band near the front of the projectile. This band keeps the projectile travelling straight in the bore supported by the lands between the rifling grooves, but doesn't engage the rifling.

As shell weight increases, it becomes more difficult to engineer a driving band that prevents propellant gases from either blowing past it, or blowing it off the shell. Tougher alloys like cupronickel may be used on major-caliber projectiles. Rotating band width of about one-third of the projectile caliber provides superior performance, but two narrower bands, separated by a short distance, have been used to conserve strategic metals in wartime. Each band is secured in a dovetailed notch machined into the projectile. Waved ridges, longitudinal nicks, or knurling is machined into the bottom of the notch to prevent the band from slipping around the projectile as the projectile accelerates down the gun barrel. The rotating band is made of a ring of slightly greater diameter than the projectile, slipped into position while thermally expanded, and pressed radially into place with a powerful hydraulic banding press.

See also

  • Cannelure
  • Gas check
  • Obturation
  • Sabot (firearms)
  • Rotating gas-check

References

  • Big Bullets for Beginners
  • [https://cuttingedgebullets.com/pages/cutting-edge-bullet-design]
  • [https://www.youtube.com/watch?v=kr6dgNjo37o]
  • [https://www.mdpi.com/2073-8994/12/7/1190]